Filter
Top Products
27-14
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 27 Monitoring Cable Technologies
Configure DEPI and L2TP
Configure DEPI and L2TP
These commands help in configuring the Downstream External PHY Interface (DEPI) and Layer 2
Tunnel Protocol (L2TP). The table below lists the navigation of each of these commands. To run these
commands, the software on the network element must support the technology. Before executing any
commands, you can preview them and view the results.
For details on the supported device list for these configuration commands and the software versions
Prime Network supports for the supported network elements, see Cisco Prime Network 4.0 Supported
Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Configure DEPI Class and Tunnel
Configure L2TP Class
View DEPI Tunnel, DEPI Session, and L2TP Class
Command Navigation Description
Create DEPI Class
Delete DEPI Class
Create DEPI Tunnel
Modify DEPI Tunnel
Delete DEPI Tunnel
NE >
Commands > Configurati
on > DEPI
Configures template of DEPI control plane
and tunnel configuration settings.
Command Navigation Description
Create L2TP Class
Modify L2TP Class
Delete L2TP Class
NE >
Commands > Configurati
on > L2TP
Configures a template of Layer 2 Tunnel
Protocol (L2TP) control plane configuration
settings.
Command Navigation Description
Show > L2TP Class
Show > DEPI Tunnel
Show > DEPI Session
Show > Cable DEPI
Session
NE > Commands >
Configuration
Displays Layer 2 Tunnel Protocol control
plane configuration settings.
Displays DEPI tunnel configuration
settings.
Displays DEPI session information and
DEPI sessions configured on the line card.