Filter
Top Products
18-61
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 18 Monitoring MPLS Services
Configuring Bundle Ethernet
Configuring Bundle Ethernet
Configure a bundle of one or more ports to form a single link using bundle ethernet commands.
The table below lists the Bundle Ethernet configuration commands. Additional commands may be
available for your devices. New commands are often provided in Prime Network Device Packages,
which can be downloaded from the Prime Network software download site. For more information on
how to download and install DPs and enable new commands, see the information on “Adding Additional
Device (VNE) support” in the Cisco Prime Network 4.0 Administrator Guide.
To run the these commands, the software on the network element must support the technology. Before
executing any commands, you can preview them and view the results. For details on the software
versions Prime Network supports for the listed supported network elements, see Cisco Prime Network
4.0 Supported Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Description
1
1. Modify commands can be used to delete specific attributes, whereas the delete commands deletes the complete configuration.
Create VRRP Group
Delete VRRP Interface
Routing Entities > Routing
Entity> IP Interfaces tab,
right-click the required
interface > Commands >
Configuration
Configure a group of routers to form a
single virtual router.
Example is using VRRP group as default
router on the client. The LAN clients can
be configured with the virtual router as
their default gateway thus avoiding single
point of failure, which was the case in
dynamic discovery protocol.
Modify VRRP Group
Delete VRRP
Show VRRP
Routing Entities > Routing
Entity> IP Interfaces tab,
double-click on the VRRP
configured interface > select
VRRP Group tab >
right-click on required group.
Command Navigation Description
1
1. Modify commands can be used to delete specific attributes, whereas the delete commands deletes the complete configuration.
Configure Bundle
Ethernet
Physical Inventory > Chassis
> Slot > Ethernet Port
> Commands >
Configuration >
Configuring an Ethernet link bundle
involves creating a bundle and adding
member interfaces to that bundle.