Filter
Top Products
25-108
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
LTE Networks
Table 25-68 LMA Service Details
Field Description
Service Name The unique service name of the LMA.
Status The status of the LMA service, which can be any one of the following:
• Down
• Running
• Initiated
• Unknown.
This field defaults to Down.
Local IPv6 Address The IP address of the interface serving as S2a (that is connected to HSGW)
or S5/S8 (that is connected to S-GW) interface.
Local IPv4 Address The IP address of the interface connected to HA/P-GW.
Local IP Port The User Datagram Protocol (UDP) port for the LMA service.
Max Subscribers The maximum number of subscribers that the LMA service can support. This
number can be any value between 0 and 3000000.
Default Subscriber
Name
The name of the subscriber template to be used for subscribers who are using
this domain alias.
Mobility Option Type
Value
The mobility option type used in mobility messages, which can be any one
of the following:
• Custom 1
• Custom 2
• Standard
Refresh Advice Option Indicates whether refresh advice option must be included in the Binding
Acknowledgement sent by the LMA service. By default, this option is
disabled.
Refresh Interval The percent of granted lifetime to be used in the Refresh Interval Mobility
option pertaining to the Binding Acknowledgement sent by the LMA
service. This percentage can be any value between 1 and 99 and defaults to
75.
Setup Timeout The maximum time (in seconds) allowed for the session to setup. This field
defaults to 60.
Lifetime The registration lifetime (in seconds) of the mobile IPv6 session. This
number can be any value between 1 and 262140.
Bind Revocation Indicates whether the binding revocation support is available for the LMA
service. By default, this option is disabled.
Bind Revocation Max
Retries
The maximum number of retries for the binding revocation, which can be
any value between 1 and 10. This field defaults to 3.
Bind Revocation
Timeout
The time interval (in milliseconds) of the retransmission of the binding
revocation, which can be any value between 500 and 10000. This field
defaults to 3000.
Sequence Number
Validation
Indicates whether the sequence number of the MIPv6 control packet received
by the LMA service must be validated. This option is enabled by default.