Filter
Top Products
27-12
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 27 Monitoring Cable Technologies
View Upstream and Downstream Configuration for Cable
Configure Cable Interfaces
View Upstream and Downstream Configuration for Cable
Configure QAM
These commands help in configuring the Quadrature Amplitude Modulation (QAM) domain for the RF
channel. The table below lists the navigation of each of these commands. To run the these commands,
the software on the network element must support the technology. Before executing any commands, you
can preview them and view the results.
For details on the supported device list for these configuration commands and the software versions
Prime Network supports for the supported network elements, see Cisco Prime Network 4.0 Supported
Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Description
Create IP Interface Logical Inventory >
Routing Entities >
Routing Entity >
Commands >
Configuration
Configure IP interface as part of the routing entity
for the selected device.
Modify IP Interface
Delete IP Interface
Logical Inventory >
Routing Entities >
Routing Entity > select
an interface >
Commands >
Configuration
Changes or removes descriptive information that
is displayed in GUI clients when the interface is
selected.
Command Navigation Description
Show > Upstream
Show > Downstream
Physical Inventory >
Ethernet Slot > navigate
to Ethernet port >
Commands >
Configuration > Port
View the configured upstream and downstream
rate for the selected cable.