13-6
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 13 Monitoring Carrier Grade NAT Properties
Configuring CG NAT Service
Figure 13-2 Carrier Grade NAT Properties in Physical Inventory
The field CGN Service is displayed, and the entry is hyperlinked to the associated Carrier Grade NAT
service in logical inventory.
Configuring CG NAT Service
The following commands can be launched from the inventory by right-clicking the appropriate node and
selecting Commands.
The table below lists the configuration commands and the supported network elements. Before executing
any commands, you can preview them and view the results. If desired, you can also schedule the
commands.
For details on the software versions Prime Network supports for thes supported network elements, see
the Cisco Prime Network 4.0 Supported Cisco VNEs. To run the Carrier Grade NAT commands, the
software on the network element must support the Carrier Grade NAT technology.
Additional commands may be available for your devices. New commands are often provided in Prime
Network Device Packages, which can be downloaded from the Prime Network software download site.
For more information on how to download and install DPs and enable new commands, see the
information on “Adding Additional Device (VNE) support” in the Cisco Prime Network 4.0
Administrator Guide.