Filter
Top Products
14-16
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 14 Monitoring DWDM Properties
Configuring and Viewing DWDM
Additional commands may be available for your devices. New commands are often provided in Prime
Network Device Packages, which can be downloaded from the Prime Network software download site.
For more information on how to download and install DPs and enable new commands, see the
information on “Adding Additional Device (VNE) support” in the Cisco Prime Network 4.0
Administrator Guide.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Input Required and Notes
Controller Data Show > N/A; performed from command launch point
PM History Data PM interval type: 15-min or 24-hour
Interval number
RTPM Counters PM interval type: 15-min or 24-hour
RTPM Threshold PM interval type: 15-min or 24-hour
Wavelength Map N/A; performed from command launch point
IM Trace Details Card location (for example, 0/5/CPU0)
Device Log N/A; performed from command launch point
Counters Clear > N/A; performed from command launch point
Channel Configure > Channel number
Option: Set or reset channel
FEC Mode G.709 FEC mode: Disabled, enhanced, or
standard
G.709 ODU ODU alarm type: ais, bdi, lck, oci, ptim, or tim
Option: Enable or disable alarm type
G.709 OTU OTU alarm type: bdi, fecmismatch, iae, lof,
lom, los, sd-ber, sf-ber, or tim
Option: Enable or disable alarm type