Filter
Top Products
25-58
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
LTE Networks
• A10/A11 Properties—The A10/A11 interface (also known as R-P interface for RAN-to-PDSN)
supports the A10 protocol for user data transport between the PCF and PDSN, and the A11 protocol
for the associated signaling. A11 signaling messages are also used for passing accounting related
and other information from the PCF to the PDSN. The A10/A11 interfaces support mobility between
PCFs under the same PDSN. See Viewing the A10/A11 Configuration Details, page 25-58.
• GRE Parameters—Generic Routing Encapsulation (GRE) is a tunneling protocol developed by
Cisco Systems that can encapsulate a wide variety of network layer protocols inside virtual
point-to-point links over an Internet Protocol internetwork. See Viewing the GRE Parameters,
page 25-59.
• IP Source Violation—IP source violations occur when the PDSN receives packets from a subscriber
where the source address is not the same as the address given to the subscriber, and hence get
discarded. See Viewing the IP Source Violation Details, page 25-60.
Viewing the A10/A11 Configuration Details
To view the A10/A11 configuration details:
Step 1 Right-click the required device in Prime Network Vision and choose Inventory.
Step 2 In the logical inventory window, choose Logical Inventory > Context > Mobile > HSGW > HSGW
service > A10/A11 Properties. The configuration details are displayed in the content pane.
Table 25-32 displays the A10/A11 configuration details.
Table 25-32 A10 A11 Configuration Details
Field Description
Overload Policy The method used by the HSGW service to handle overload conditions, which
can be any one of the following:
• Reject
• Redirect
New Call Policy The new call policy configured for the HSGW service, which can be any one
of the following:
• None
• Reject
• Accept
This field defaults to None.
Data Available
Indicator Enabled
Indicates whether the data available indicator in A10/A11 registration reply
messages is enabled.
Data Over Signalling Indicates whether the data over signaling marking feature for A10 packets is
enabled.
Airlink Bad Sequence The behavior for airlink related parameters configured for the HSGW
service, which can be any one of the following:
• Accept
• Deny