Filter
Top Products
20-2
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 20 Monitoring MToP Services
Viewing SAToP Pseudowire Type in Logical Inventory
The following tables identify the tasks that you can perform:
• Table 20-1 identifies the tasks that you can perform if a selected element is not in one of your
assigned scopes.
• Table 20-2 identifies the tasks that you can perform if a selected element is in one of your assigned
scopes.
By default, users with the Administrator role have access to all managed elements. To change the
Administrator user scope, see the topic on device scopes in the Cisco Prime Network 4.0 Administrator
Guide.
Viewing SAToP Pseudowire Type in Logical Inventory
Structure-Agnostic Time Division Multiplexing (TDM) over Packet (SAToP) enables the encapsulation
of TDM bit-streams (T1, E1, T3, or E3) as pseudowires over PSNs. As a structure-agnostic protocol,
SAToP disregards any structure that might be imposed on the signals and TDM framing is not allowed.
To view the SAToP pseudowire type in logical inventory:
Step 1 In Prime Network Vision, right-click the device on which SAToP is configured, then choose Inventory.
Step 2 In the inventory window, choose Logical Inventory > Pseudowires.
Step 3 In the Tunnel Edges table, select the required entry and scroll horizontally until you see the Pseudowire
Type column. See Figure 20-1.
Note You can also view this information by right-clicking the entry in the table and choosing
Properties.
Table 20-1 Default Permission/Security Level Required for Viewing MToP Properties - Element
Not in User’s Scope
Task Viewer Operator OperatorPlus Configurator Administrator
View MToP properties — — — — X
Using SONET
Configure, Clear, and
Show Commands
——— X X
Table 20-2 Default Permission/Security Level Required for Viewing MToP Properties - Element in
User’s Scope
Task Viewer Operator OperatorPlus Configurator Administrator
View MToP properties X X X X X
Using SONET
Configure, Clear, and
Show Commands
——— X X