Filter
Top Products
25-61
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
LTE Networks
Configuration Commands for HSGW
The HSGW commands allow you to configure HSGW services in your network. Please note that these
commands are available only for Cisco ASR 5000 Mobile devices.
These commands can be launched from the logical inventory by choosing the
Context > Commands > Configuration or Context > Commands > Show.
Before executing any commands, you can preview them and view the results. If desired, you can also
schedule the commands.
The table below lists the HSGW commands. Additional commands may be available for your devices.
New commands are often provided in Prime Network Device Packages, which can be downloaded from
the Prime Network software download site. For more information on how to download and install DPs
and enable new commands, see the information on “Adding Additional Device (VNE) support” in the
Cisco Prime Network 4.0 Administrator Guide.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Table 25-35 lists the HSGW configuration commands.
Table 25-34 IP Source Violation Configuration Details
Field Description
Renegotiation Limit The number of source violations that are allowed within a specified detection
period, after which a PPP renegotiation is forced.
Drop Limit The number of source violations that are allowed within a specified detection
period, after which a call disconnect is forced.
Clear On Valid PDU Indicates whether the service must reset the renegotiation limit and drop
limit counters if a properly addressed packet is received.
Period The amount of time (in seconds) for the source violation detection period.
Once this value is reached, the drop limit and renegotiation limit counters are
decremented.
Table 25-35 HSGW Configuration Commands
Command Navigation Description
Create HSGW Right-click context > Commands >
Configuration
Use this command to create a new
HSGW service.
Modify HSGW
Delete HSGW
Expand HSGW node > right-click HSGW
service > Commands > Configuration
Use this command to modify/delete
the configuration details of an HSGW
service.
Show HSGW Expand HSGW node > right-click HSGW
service > Commands > Show
Use this command to view and confirm
the configuration details of an HSGW
service.