Filter
Top Products
18-33
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 18 Monitoring MPLS Services
Monitoring MPLS Services
VRRP Group If a VRRP group is configured on an IP interface, the information is shown
as an IP interface property. This option is checked when a rate limit is defined
on the IP interface.
Note Double-clicking a row displays the properties of the IP interface.
When a VRRP group is configured on an IP interface, the VRRP
Groups tab is displayed in the IP Interface Properties window. For
more information, see Viewing VRRP Information, page 18-37.
Output Access List If an output access list is assigned to an IP interface, the list is shown as an
IP interface property, and a hyperlink highlights the related access list in the
Access List table. When an access list is assigned to the outbound traffic on
an IP interface, the actions assigned to the packet are performed.
Rate Limits If a rate limit is configured on an IP interface, the limit is shown as an IP
interface property. This option is checked when a rate limit is defined on the
IP interface, meaning the access list is a rate limit access list. IP interface
traffic is measured and includes the average rate, normal burst size, excess
burst size, conform action, and exceed action.
Note Double-clicking a row displays the properties of the IP interface.
When a rate limit is configured on the IP interface, the Rate Limits
tab is displayed. For more information, see Viewing Rate Limit
Information, page 18-36.
Note The Input Access, Output Access, and Rate Limits parameters apply
only to Cisco IOS devices.
IP Sec Map Name IP Security (IPsec) crypto map name.
Site Name Name of the business element to which the interface is attached.
IPv4 and IPv6 Routing Table Tabs
Destination Destination of the specific network.
Outgoing If Name Name of the outgoing interface.
Type Routing type: Direct, Indirect, Static, Other, Invalid, or Unknown.
Next Hop IP address from which to continue to get to a specific address. This field is
empty when the routing entry goes to a PE router.
Prefix Length Length of the network prefix in bits.
Route Protocol Type Routing protocol used to communicate with other routers.
IPv4 and IPv6 Multicast Routing Tabs
Source Address The source IP address from where the multicast information is sent.
Group Address The group IP address of the multicast.
Flags The flag information pertaining to the multicast.
Up Time The amount of time the interface has been active.
Protocol The protocol information, which can be 4 or 6.
Table 18-12 Routing Entity Table (continued)
Field Description