Filter
Top Products
25-133
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
Working with Active Charging Service
Table 25-80 describes the details available for each rule definition group.
Rule Definition Group Commands
The following commands can be launched from the inventory by right-clicking a rule definition group
and choosing Commands > Configuration or Commands > Show. Before executing any commands,
you can preview them and view the results. If desired, you can also schedule the commands. To find out
if a device supports these commands, see the Cisco Prime Network 4.0 Supported Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Viewing Rule Base for the Charging Action
A rule base is a collection of rule definitions and their associated billing policy. The rule base determines
the action to be taken when a rule is matched. A maximum of 512 rule bases can be specified in the ECS
service. It is possible to define a rule definition with different actions.
Rule bases can also be used to apply the same rule definitions for several subscribers, which eliminate
the need to have unique rule definition for each subscriber. We can set priority, default bandwidth policy,
type of billing for subscriber sessions, for a rule definition/ group of rule definitions in the rule base.
Additionally we can configure content based billing and firewall/NAT constituent to rule base.
Table 25-80 Rule Definition Group Properties in Logical Inventory
Field Description
Name Name of the rule definition group.
Application Type Purpose of the rule definition group, which could be charging, routing,
content filtering, post-processing, or Traffic Performance Optimization
(TPO).
Dynamic Command
Content Filtering Policy
ID
Content filtering policy ID to add or remove dynamic commands from the
rule definition group.
Table 25-81 Rule Definition Group Commands
Command Type Command Inputs Required and Notes
Configuration Delete Group of RuleDefs Click Execute Now to delete the rule
definition group.
Show Show Group of RuleDefs Click Execute Now to display the group of
rule definitions.