Filter
Top Products
25-12
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
GPRS/UMTS Networks
GTPU Commands
The following commands can be launched from the inventory by right-clicking a GTPU and choosing
Commands > Configuration.
The table below lists the GTPU configuration commands. Additional commands may be available for
your devices. New commands are often provided in Prime Network Device Packages, which can be
downloaded from the Prime Network software download site. For more information on how to download
and install DPs and enable new commands, see the information on “Adding Additional Device (VNE)
support” in the Cisco Prime Network 4.0 Administrator Guide.
Before executing any commands, you can preview them and view the results. If desired, you can also
schedule the commands. To find out if a device supports these commands, see the Cisco Prime Network
4.0 Supported Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Table 25-8 GTPU Properties in Logical Inventory
Field Description
Service Name The name of the GTPU service.
State The status of the GTPU service. Status could be Unknown, Running, or
Down.
Max Retransmissions The maximum limit for GTPU echo retransmissions. Default value is 4.
Retransmission
Timeout
The timeout in seconds for GTPU echo retransmissions. Default value is 5
Secs.
Echo Interval The rate at which the GTPU echo packets are sent.
IPSEC Tunnel Idle
Timeout
The IPSec tunnel idle timeout after which IPSec tunnel deletion is triggered.
Default value is 60 Secs.
Allow Error Indication Specifies whether error indication is dropped or sent without IPSec tunnel.
Default value is Disabled.
Include UDP Port Ext
Hdr
Specifies whether to include an extension header in the GTPU packet for
error indication messages. Default value is False.
IP Address The list of IP addresses configured on the GTPU. The IP addresses are
available only when configured for the GTPU.