Filter
Top Products
18-59
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 18 Monitoring MPLS Services
Configuring BGP
Configuring BGP
Multiprotocol BGP is an enhanced BGP that carries routing information for multiple network layer
protocols and IP multicast routes. BGP commands configure the routing protocol to communicate with
the other sites and VRFs.
Note BGP neighbors should be configured as part of BGP routing. At least one neighbor and at least one
address family must be configured to enable BGP routing.
The table below lists the commands that will be used to configure BGP Routing Protocol on Cisco
Routers. Additional commands may be available for your devices. New commands are often provided
in Prime Network Device Packages, which can be downloaded from the Prime Network software
download site. For more information on how to download and install DPs and enable new commands,
see the information on “Adding Additional Device (VNE) support” in the Cisco Prime Network 4.0
Administrator Guide.
To run the these commands, the software on the network element must support the technology. Before
executing any commands, you can preview them and view the results. For details on the software
versions Prime Network supports for the listed supported network elements, see Cisco Prime Network
4.0 Supported Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Description
1
1. Modify commands can be used to delete specific attributes, whereas the delete commands deletes the complete configuration.
Configure RSVP LSEs > right-click Label Switching >
Commands > Configuration >
Configure RSVP on a device
or an interface.
Delete RSVP
Enable RSVP On
Interface
Disable RSVP On
Interface
Routing Entities > Routing Entity> IP
Interfaces tab, right-click the required
interface > Commands > Configuration