20-53
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 20 Monitoring MToP Services
Configuring SONET
Figure 20-28 CEM Group Properties
Step 4 To view additional CEM group properties, double-click the required CEM group.
Table 20-23 describes the information displayed in the CEM Group Properties window.
Configuring SONET
These commands help in configuring the SONET device and in viewing device details.
The table below lists the SONET commands can be launched from the inventory by right-clicking a
SONET port and selecting Commands > SONET. Additional commands may be available for your
devices. New commands are often provided in Prime Network Device Packages, which can be
downloaded from the Prime Network software download site. For more information on how to download
and install DPs and enable new commands, see the information on “Adding Additional Device (VNE)
support” in the Cisco Prime Network 4.0 Administrator Guide.
To run the these commands, the software on the network element must support the technology. Before
executing any commands, you can preview them and view the results. For details on the software
versions Prime Network supports for the listed supported network elements, see Cisco Prime Network
4.0 Supported Cisco VNEs.