Filter
Top Products
20-54
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 20 Monitoring MToP Services
Configuring SONET
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Command Navigation Description
BER Threshold Right-click on SONET port and
select Commands > SONET >
Show >
Performed from command launch point
Controller Data
TCA Threshold
SDH Counters Clear > SONET > N/A; performed from command launch
point
BER Threshold Right-click on SONET port and
select Commands > SONET >
Configure >
BER threshold:
• sf-ber—Sets the signal failure BER
threshold. Value in the range from
3 to 9. The default value is 6
• sd-ber—Sets the signal degrade
BER threshold. Value in the range
from 3 through 9. The default value
is 3
Bit error rate: 3-9, or default. The
default for sf-ber is 3, and the default
for sd-ber is 9.
Line Counters Right-click on SONET port and
select Commands > SONET >
Show > PM
Line type: farendline,
farendline-history, line, or line-history
History interval: 1-96; to view all, enter
0
Medium Counters N/A; performed from command launch
point
Path type: farendpath,
farendpath-history, path, path-history
Path Counters Channelized path index: 1-48 (for a
particular channel) or 0 (for all
channels)
History interval: 1-96; to view all, enter
0
Section Counters Right-click on SONET port and
select Commands > SONET >
Show > PM
Section type: section or section-history
History interval: 1-96; to view all, enter
0
Trace Details Card location (for example, 0/5/CPU0)
Note The device must be managed by
Prime Network with device
admin privileges.