Filter
Top Products
25-55
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
LTE Networks
The Authentication features supported by HSGW are:
• EAP over PPP
• UE and HSGW negotiates EAP as the authentication protocol during LCP
• HSGW is the EAP authenticator
• EAP-AKA’ (trusted non-3GPP access procedure) as specified in TS 33.402
• EAP is performed between UE and 3GPP AAA over PPP/STa
The IP Address Allocation features supported by HSGW are:
• Support for IPv4 and IPv6 addressing
• Types of PDNs - IPv4, IPv6 or IPv4v6
• IPv6 addressing
–
Interface Identifier assigned during initial attach and used by UE to generate it’s link local
address
–
HSGW sends the assigned /64 bit prefix in RA to the UE
–
Configure the 128-bits IPv6 address using IPv6 SLAAC (RFC 4862)
–
Optional IPv6 parameter configuration via stateless DHCPv6(Not supported)
• IPv4 address
–
IPv4 address allocation during attach
–
Deferred address allocation using DHCPv4(Not supported)
–
Option IPv4 parameter configuration via stateless DHCPv4(Not supported)
The Quality of Service features supported by HSGW include:
• HRPD Profile ID to QCI Mapping
• DSCP Marking
• UE Initiated Dedicated Bearer Resource Establishment
• QCI to DSCP Mapping
The AAA, Policy and Charging features supported by HSGW include:
• EAP Authentication (STa)
• Rf Diameter Accounting
• AAA Server Groups
• Dynamic Policy and Charging: Gxa Reference Interface
• Intelligent Traffic Control
Viewing the HSGW Configuration
To view the HSGW configuration:
Step 1 Right-click the required device in Prime Network Vision and choose Inventory.
Step 2 In the logical inventory window, choose Logical Inventory > Context > Mobile > HSGW. The list of
HSGW services configured in Prime Network are displayed in the content pane.
Step 3 From the HSGW node, choose a HSGW service. The HSGW service details are displayed in the content
pane as shown in Figure 25-7.