Filter
Top Products
20-43
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 20 Monitoring MToP Services
Network Clock Service Overview
Step 4 To view recovered clock entries, click the Recovered Clock Entries tab. See Figure 20-22.
If no recovered clock entries exist, this tab is not displayed.
Table 20-23 CEM Group Properties
Field Description
Oper Status Operational status of the CEM interface:
• Dormant—The interface is dormant.
• Down—The interface is down.
• Not Present—An interface component is missing.
• Testing—The interface is in test mode.
• Unknown—The interface has an unknown operational status.
• Up—The interface is up.
Idle Pattern Eight-bit hexadecimal number that is transmitted on a T1 or E1 line
when missing packets are detected on the pseudowire (PW) circuit.
Type Type of CEM group. This is always DS0 Bundle.
Idle CAS Pattern When CAS is used, the 8-bit hexadecimal signal that is sent when
the CEM interface is identified as idle.
Bundle Location Associated card and slot for the virtual CEM, using the virtual CEM
port 24; for example virtual-cem/8/3/24:0.
Dejitter Size of the dejitter buffer in milliseconds (ms). The range is 4 to 500
ms with a default of 4 ms.
RTP Hdr Compression Whether RTP header compression is enabled or disabled.
RTP Enabled Whether RTP compression is enabled or disabled.
Admin Status Administrative status of the CEM interface:
• Down—The CEM interface is administratively down.
• Testing—The administrator is testing the CEM interface.
• Unknown—The administrative status is unknown.
• Up—The CEM interface is administratively up.
ID DS0 bundle CEM group identifier.
Payload Size Size of the payload for packets on the CEM interface. The range is
32 to 1312 bytes.