Filter
Top Products
18-53
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 18 Monitoring MPLS Services
Configuring VRF
The Traffic Engineering LSPs tab in the LSEs branch in logical inventory displays TE tunnel LSP
information.
For details about the information displayed for TE tunnel LSPs, see Traffic Engineering LSPs,
page 18-40.
Configuring VRF
VRF commands configures routes that are available or reachable to all the destinations or networks in
the VRF.
Unless otherwise noted, all of the following commands are launched by right-clicking the VRF node and
choosing Commands > Configuration.
The table below lists the VRF commands. Additional commands may be available for your devices. New
commands are often provided in Prime Network Device Packages, which can be downloaded from the
Prime Network software download site. For more information on how to download and install DPs and
enable new commands, see the information on “Adding Additional Device (VNE) support” in the Cisco
Prime Network 4.0 Administrator Guide.
To run the these commands, the software on the network element must support the technology. Before
executing any commands, you can preview them and view the results. For details on the software
versions Prime Network supports for the listed supported network elements, see Cisco Prime Network
4.0 Supported Cisco VNEs.
Note You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Burst (Kbps) Burst flow specification (in Kb/s) for this tunnel.
Peak Rate (Kbps) Peak flow specification (in Kb/s) for this tunnel.
LSP ID LSP identifier.
Policy Class Value of Policy Based Tunnel Selection (PBTS) configured. Values range
from 1-7.
FRR TE Fast Reroute (FRR) status: Enabled or Disabled.
Type
Table 18-28 Tunnel Edges Table (continued)
Field Description
Command Description
Modify VRF
Delete VRF
Configures VRF properties, including the VRF route
distinguisher, import and export route targets, and any
provisioned sites and VRF routes.