Filter
Top Products
4-67
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 4 Device Configurations and Software Images
Global Settings and Administration
File Locations Full pathname of directories where images are stored when they are being imported into the
Prime Network image repository, or when they are being transferred out of the repository to devices.
New directories must be empty and have the proper permissions (read, write, and execute permissions
for users).
The entries must be full pathnames. In the following default locations, PRIME_NETWORK_HOME
is the Prime Network installation directory, normally /export/home/network-user; where network-user
is the operating system user for the Prime Network application and an example of network-user is
network39.
Staging Directory Location where images from the Prime Network image repository are placed
before transferring them out to devices. The default is
PRIME_NETWORK_HOME/NCCMComponents/NEIM/staging/.
Storing Directory Location where images from an outside source are placed before importing them
into the Prime Network image repository (from Cisco.com, from existing
devices, or from another file system). The default is
PRIME_NETWORK_HOME/NCCMComponents/NEIM/images/.
External Server
Details
Details about external server from which images can be imported into repository.
Server Name IP address of the external server (IPv4 or IPv6 addresses supported).
Image Location Path where the image is located on the server.
User Name Username to access the external server.
Password Password to access the external server.
SSH Port SSH port ID to connect to the server.
E-mail Settings Settings for automatic e-mail notifications about the status of jobs.
SMTP Host SMTP server to use for sending e-mail notifications on the status of image
management jobs to users. If an SMTP host is configured in the Configuration
Management Settings page, the same value will be displayed here by default. You
can modify it, if required.
E-mail Id(s) E-mail address of the user to send a notification to after the scheduled job is
complete. For two or more users, enter a comma-separated list of e-mail
addresses. For example:
xyz@cisco.com,abc@cisco.com
The e-mail IDs configured here will appear by default while scheduling the
image management jobs. However, you can add/modify the e-mail IDs then.
SMTP Port SMTP port ID to connect to the host server. The default port is 25.
Email Option Controls when e-mail notifications for NEIM jobs are sent (can be overridden
when creating the job):
• All—Send a notification irrespective of the job result.
• Failure—Send a notification e-mail only when the job has failed.
• No Mail—Do not send a notification e-mail on the job status.
Table 4-9 Image Management Global Settings (continued)
Field Description