Filter
Top Products
12-116
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 12 Monitoring Carrier Ethernet Services
Viewing IS-IS Properties
Table 12-48 describes the information that is displayed for the selected IS-IS process.
Table 12-48 IS-IS Process Properties in Logical Inventory
Field Description
Process Unique identifier for the IS-IS process.
System ID Identifier for this Intermediate System.
IS Type Level at which the Intermediate System process is running: Level 1,
Level 2, or Level 1-2.
Manual Area Address Address assigned to the area.
Metrics Tab
IS Type Level at which the Intermediate System is running: Level 1, Level
2, or Level 1-2.
Metric Style Metric style used: Narrow, Transient, or Wide.
Metric Value Metric value assigned to the link. This value is used to calculate the
path cost via the links to destinations. This value is available for
Level 1 or Level 2 routing only.
If the metric style is Wide, the value can range from 1 to 16777214.
If the metric style is Narrow, the value can range from 1 to 63.
The default value for active IS-IS interfaces is 10, and the default
value for inactive IS-IS interfaces is 0.
Address Family IP address type used: IPv4 or IPv6.
Interfaces Tab
Interface Name Interface name.
Neighbors Tab
System ID Identifier for the neighbor system.
Interface Neighbor interface name.
IP Address Neighbor IP address.
Type IS type for the neighbor: Level 1, Level 2, or Level 1-2.
SNPA Subnetwork point of attachment (SNPA) for the neighbor.
Hold Time Holding time, in seconds, for this adjacency. The value is based on
received IS-to-IS Hello (IIH) PDUs and the elapsed time since
receipt.
State Administrative status of the neighbor system: Up or Down.
Address Family IP address type used by the neighbor: IPv4 or IPv6.