24-7
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 24 Monitoring BNG Configurations
Working with BNG Configurations
View Dynamic Host Configuration Protocol (DHCP) Service Profile
DHCP is used to automate host configuration by assigning IP addresses, delegating prefixes (in IPv6),
and providing extensive configuration information to network computers.
DHCP has the capability to allocate IP addresses only for a specified period of time, which is known as
the lease period. If a client device wants to retain the IP addresses for a period longer than the lease
period, then the client must renew the lease before it expires. A client can renew the lease depending on
the configuration time sent from the server. A REQUEST message is unicast by the client using the
server's IP address. On receiving the REQUEST message, the server responds with an acknowledgment,
and the client's lease is extended by the lease time configured in the acknowledgment message.
To view the DHCP service profile:
Step 1 Right-click on the required device and choose the Inventory option.
Step 2 In the Inventory window, choose Logical Inventory > DHCP Service > DHCP Profiles - IPv4. A list
of DHCP profiles are displayed in the content pane as shown in Figure 24-3.
Show PPoE Trace
• Trace Filter Type
• Trace Count
Show Subscriber Dynamic Template Trace All
• Trace Filter Type
• Trace Event Type
• Trace Count
Show Subscriber Manager Disconnect History Disconnect History Filter Type
Show Subscriber Manager Session History
• Session Type
• ID Value
Show Subscriber Manager Trace
• Trace Filter Type
• Trace Event Type
• Trace Count
Show Subscriber Session Details by Filter
• Session Filter Type
• Filter Value
• Filter State
Table 24-4 Diagnose Subscriber Access Points (continued)
Diagnose Command Input parameters