Filter
Top Products
1-6
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 1 Setting Up Devices and Using the GUI Clients
Setting Up Devices and Validating Device Information
Configure a Device NTP Server
Configure RADIUS or TACACS Server on Device
Configure IP Access Control Lists (ACLs) on Device
Note These commands are not available on Cisco IOS XR devices.
Caution Only advanced users should change ACLs.
Command Description
NTP > Add NTP Server
NTP > Remove NTP Server
Assigns the device to a Network Time Protocol (NTP) server to
manage clock synchronization.
Command Description
TACACS > Add Tacacs Server
TACACS > Remove Tacacs Server
Assigns the device to a Terminal Access Controller
Access-Control System (TACACS) server to manage
authentication (uses TCP or UDP).
TACACS+ > Add Tacacs+ Server
TACACS+ > Remove Tacacs+ Server
Assigns the device to a TACACS+ server to manage
authentication (uses TCP).
RADIUS > Add Radius Server
RADIUS > Remove Radius Server
Assigns the device to a Remote Authentication Dial In User
Service (RADIUS) server to manage centralized
authentication, authorization, and accounting (uses UDP)
.
Command Navigation Description
Remove Access
List
Logical Inventory >
Access Lists > ACL >
Commands > Configuration >
System
Removes an NE’s IP ACL, which filters
traffic by forwarding or blocking routed
packets depending on the ACL entry
configurations.
Remove Access
List Entry
Logical Inventory >
Access Lists > double-click ACL >
ACL entry > Commands >
Configuration > System
Removes the specified ACL entry from the
IP ACL.