Filter
Top Products
12-85
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 12 Monitoring Carrier Ethernet Services
Working with VPLS and H-VPLS Instances
Viewing Virtual Switching Instance Properties
To view VSI properties in Prime Network Vision, open the VSI properties window in either of the
following ways:
• Double-click the required device and, in the inventory window, choose Logical
Inventory > VSIs > vsi.
• In the navigation pane, expand the VPLS instance, right-click the required VPLS forward, and
choose Inventory or Properties. (See Figure 12-48.)
VPN ID VPN identifier for the VSI.
Access Pseudowires Tab
Name Pseudowire name.
Port VSI on which the pseudowire is configured, hyperlinked to the entry
in logical inventory.
Local Router IP Local router IP address on which the pseudowire is configured.
Tunnel ID Virtual circuit identifier of the pseudowire.
PTP Tunnel Hyperlinked entry to the pseudowire properties in logical inventory.
Peer Router IP Peer router IP address on which the pseudowire is configured.
Peer OID Hyperlinked entry to the pseudowire properties of the peer.
Pseudowire Type Type of pseudowire, such as Ethernet, Ethernet Tagged, CESoPSN
Basic, PPP, or SAToP.
Pseudowire Edge Binding
Type
Pseudowire endpoint association:
• 0—Unknown
• 1—Connection termination point
• 2—Ethernet flow point
• 3—Switching entity
• 4—Pseudowire switching entity
• 5—VPLS forward
Access Flow Points Tab
Name Access flow point name. Double-click to view port connector
properties.
Port Interface configured as a flow point, hyperlinked to the interface in
physical inventory.
Table 12-37 VPLS Instance Properties (continued)
Field Description