Filter
Top Products
18-57
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 18 Monitoring MPLS Services
Configuring MPLS-TE
Configuring MPLS-TE
Use these commands to configures MPLS-TE on the router. The table below lists the MPLS-TE
configuration commands and the MPLS-TE supported network elements. Additional commands may be
available for your devices. New commands are often provided in Prime Network Device Packages,
which can be downloaded from the Prime Network software download site. For more information on
how to download and install DPs and enable new commands, see the information on “Adding Additional
Device (VNE) support” in the Cisco Prime Network 4.0 Administrator Guide.
To run the these commands, the software on the network element must support the technology. Before
executing any commands, you can preview them and view the results. For details on the software
versions Prime Network supports for the listed supported network elements, see Cisco Prime Network
4.0 Supported Cisco VNEs.
You might be prompted to enter your device access credentials while executing a command. Once you
have entered them, these credentials will be used for every subsequent execution of a command in the
same GUI client session. If you want to change the credentials, click Edit Credentials. The Edit
Credentials button will not be available for SNMP commands or if the command is scheduled for a later
time.
Configuring MPLS
Multiprotocol label switching (MPLS) is a high-performance packet forwarding technology that
integrates the performance and traffic management capabilities of data link layer (Layer 2) switching
with the scalability, flexibility, and performance of network layer (Layer 3) routing. Use these
commands to enable MPLS protocol on Cisco routers.
The table below lists the MPLS configuration commands. Additional commands may be available for
your devices. New commands are often provided in Prime Network Device Packages, which can be
downloaded from the Prime Network software download site. For more information on how to download
and install DPs and enable new commands, see the information on “Adding Additional Device (VNE)
support” in the Cisco Prime Network 4.0 Administrator Guide.
To run the these commands, the software on the network element must support the technology. Before
executing any commands, you can preview them and view the results. For details on the software
versions Prime Network supports for the listed supported network elements, see Cisco Prime Network
4.0 Supported Cisco VNEs.
Command Navigation Description
1
Configure MPLS-TE
Global
LSEs > right-click Label
Switching > Commands >
Configuration >
Configures MPLS at the device level
or an interface level. Contains
information on MPLS interfaces and
whether traffic engineering tunnels are
configured.
Configure MPLS-TE
Interface
Routing Entities > Routing
Entity> IP Interfaces tab,
right-click the required
interface > Commands >
Configuration >
1. Modify commands can be used to delete specific attributes, whereas the delete commands deletes the complete configuration.