Filter
Top Products
25-101
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
LTE Networks
Viewing the QoS Configuration Details
To view the Quality of Service configuration details for a PDSN service:
Step 1 Right-click the required device in Prime Network Vision and choose Inventory.
Step 2 In the logical inventory window, choose Logical Inventory > Context > Mobile > PDSN > PDSN
service > QoS. The details are displayed in the content pane.
Table 25-64 displays the QoS configuration details.
Table 25-63 PPP Configuration Details
Field Description
Context Name The destination context where the Layer 2 Tunneling protocol Access
Concentrator (LAC) service is configured.
Note This context is the same as the PPP tunneling context.
Tunnel Type The type of the PPP tunnel established between the PDSN and the PFC,
which can be any one of the following values:
• L2TP
• None
This field defaults to None.
Fragment State Indicates whether the PPP fragmentation is enabled. By default, this is
option is disabled.
Alt PPP Indicates whether the Alternate Point-to-Point (PPP) protocol sessions are
enabled for the PDSN service. By default, this option is disabled.
Allow No
Authentication
Indicates whether subscribers can gain network access even if they have not
been authenticated.
Authentication The authentication mode and priority when multiple modes are selected,
which can be any one of the following:
• chap—Uses the Challenge Handshake Authentication Protocol (CHAP)
for authentication. Must be followed by a priority value, which can be
any value between 0 and 1000 with a lower number indicating higher
preference. This protocol is enabled by default and commands the
highest priority.
• mschap—Uses the Microsoft Challenge Handshake Authentication
Protocol (MS-CHAP) for authentication. Must be followed by a priority
value, which can be any value between 0 and 1000 with a lower number
indicating higher preference. This protocol is disabled by default.
• pap—Uses Password Authentication Protocol (PAP) for authentication.
Must be followed by a priority value, which can be any value between 0
and 1000 with a lower number indicating higher preference. This
protocol seconds CHAP in terms of priority. This protocol is enabled by
default.