Filter
Top Products
12-72
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 12 Monitoring Carrier Ethernet Services
Working with VLANs
Step 3 When finished, press Ctrl + F4 to close each VLAN Bridge properties window.
Using Commands to Work With VLANs
The following commands can be launched from the physical inventory by right-clicking an Ethernet slot
and choosing Commands > Configuration. Before executing any commands, you can preview them
and view the results. If desired, you can also schedule the commands. To find out if a device supports
these commands, see the Cisco Prime Network 4.0 Supported Cisco VNEs.
Allowed VLANs List of the VLANs allowed on this VLAN interface.
VLAN Encapsulation
Admin Type
VLAN administration encapsulation type, such as IEEE 802.1Q.
EFPs Tab
EFP ID EFP identifier.
Operational State EFP operational state.
VLAN VLAN identifier.
Inner VLAN CE-VLAN identifier.
Translated VLAN Translated VLAN identifier.
Translated Inner VLAN Translated CE-VLAN identifier.
Binding Port Hyperlinked entry to the port in physical inventory.
Description Brief description of the EFP.
Pseudowires Tab
ID Pseudowire identifier, hyperlinked to the VLAN entry in Bridges in logical
inventory.
Peer Identifier of the pseudowire peer, hyperlinked to the entry in the
Pseudowire Tunnel Edges table in logical inventory.
Tunnel ID Tunnel identifier.
Tunnel Status Status of the tunnel: Up or Down.
Peer Router IP IP address of the peer router for this pseudowire.
Sub Interfaces Tab
BER VLAN bit error rate.
Interface Name Interface on which the VLAN is configured.
VLAN Type Type of VLAN, such as Bridge or IEEE 802.1Q.
Operational State Subinterface operational state.
VLAN ID VLAN identifier.
Inner VLAN CE-VLAN identifier.
Table 12-34 VLAN Bridge Properties (continued)
Field Description