Filter
Top Products
18-27
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 18 Monitoring MPLS Services
Monitoring MPLS Services
Viewing Site Properties
Prime Network Vision enables you to view site properties, including the interfaces that are configured
on the PE device. The displayed properties reflect the configuration that Prime Network Vision
automatically discovered for the device.
To view site properties, in the Prime Network Vision navigation pane or map view, right-click the
required site and choose Properties.
Table 18-8 describes the information that is displayed in the Router IP Interface Properties window:
Viewing VRF Properties
Prime Network Vision enables you to view VRF properties, including the VRF route distinguisher,
import and export route targets, and any provisioned sites and VRF routes.
To view VRF properties, do either of the following in map view:
• Double-click the element configured for VRFs.
• Expand the required VPN and double-click the virtual router.
Table 18-8 Router IP Interface Properties Window for Sites
Field Description
Name Name of the site, such as FastEthernet4/1.252.
State Interface state, either Up or Down.
IP Address IP address of the interface.
Mask Network mask.
Interface Description Description applied to the interface.
Associated Entity Element and interface associated with the site, hyperlinked to its
entry in physical inventory.
Addresses Table
Subnet IP address and subnet mask.
Note If the site is an IPv6 VPN over MPLS with IPv6 addresses
provisioned, the IPv6 addresses are displayed. For more
information, see Viewing IPv6 Information, page 17-2.
Type Address type, such as Primary, Secondary, or IPv6 Unicast.