Filter
Top Products
25-154
Cisco Prime Network 4.0 User Guide
OL-29343-01
Chapter 25 Monitoring Mobile Technologies
Monitoring the Mobility Management Entity
Viewing the S1 Interface Configuration Details
To view the S1 Interface configuration details for a MME service:
Step 1 Right-click the required device in Prime Network Vision and choose Inventory.
Step 2 In the logical inventory window, choose Logical Inventory > Context > Mobile > MME > MME
service > S1 Interface. The interface configuration details are displayed in the content pane.
Table 25-91 displays the S1 Interface configuration details.
Table 25-90 Policy Configuration Details
Field Description
IMEI Query type The type of IMEI query use for attaching the user equipment and tracking
area update procedure,which can be any one of the following:
• imei (International Mobile Equipment Identity)
• imei-sv (International Mobile Equipment Identity-Software Version)
Set UE Time Indicates whether the MME serivce must set the time in the UE during the
attach or tracking area update procedure.
Deny Grey Listed Indicates whether the MME service must deny the grey listed equipment. In
other words, it specifies whether the identification of the UE must be
performed by the Equipment Identity Register (EIR) over the S13 interface.
Deny Unknown Indicates whether the MME service must deny service to an unknown
equipment.
Verify Emergency Indicates whether the MME service must verify the equipment for
emergency calls.
Allow On ECA Timeout Indicates whether the MME service must allow service of equipements that
timeout on the ECA.
EIR Query Type Indicates whether querying of EIR is enabled or disabled.
Table 25-91 S1 Interface Configuration Details
Field Description
Primary IP Address The IP address (IPv4 or IPv6) of the interface configured as an S1-MME
interface.
Secondary IP Address The optional IP address (IPv4 or IPv6) of the interface configured as an
S1-MME interface.
SCTP Port The source SCTP port used for binding the SCTP socket to communicate
with the eNodeB. This port can be any value between 1 and 65535, and
defaults to 699.
Max Subscribers The maximum number of subscribers that can access the MME service on
the interface. This number can be any value between 0 and 4,000,000.