Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com.
35-12
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-6965-03, Cisco MDS SAN-OS Release 2.x
Chapter 35 Troubleshooting Your Fabric
Using the Ping Tool
Permitted Capture Filters
This section lists the permitted capture filters.
o vsan
o src_port_idx
o dst_port_idx
o sof
o r_ctl
o d_id
o s_id
o type
o seq_id
o seq_cnt
o ox_id
o rx_id
o els
o swils
o fcp_cmd (FCP Command frames only)
o fcp_data (FCP data frames only)
o fcp_rsp (FCP response frames only)
o class_f
o bad_fc
o els_cmd
o swils_cmd
o fcp_lun
o fcp_task_mgmt
o fcp_scsi_cmd
o fcp_status
o gs_type (Generic Services type)
o gs_subtype (Generic Services subtype)
o gs_cmd
o gs_reason
o gs_reason_expl
o dns (name server)
o udns (unzoned name server)
o fcs (fabric configuration server)
o zs (zone server)
o fc (use as fc[x:y] where x is offset and y is length to compare)
o els (use as els[x:y] similar to fc)
o swils (use as swils[x:y] similar to fc)
o fcp (use as fcp[x:y] similar to fc)
o fcct (use as fcct[x:y] similar to fc)
Using the Ping Tool
You can use the Ping tool to determine connectivity from another switch to a port on your switch.
To use the Ping tool, follow these steps:
Step 1 Select Ping from the Fabric Manager Tools menu. You can also select it from the right-click context
menus for hosts and storage devices in the Fabric pane.
You see the Ping dialog box.
Step 2 Select the source switch from the Source Switch drop-down list.
Step 3 Select the VSAN in which you want to verify connectivity from the VSAN drop-down list.
Step 4 Select the target end port for which you want to verify connectivity from the Target Endport drop-down
list.