Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com.
26-7
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-6965-03, Cisco MDS SAN-OS Release 2.x
Chapter 26 SNMP Configuration
Configuring SNMP Notifications
Note Use the SNMP-TARGET-MIB to obtain more information on trap destinations and inform requests.
Refer to the Cisco MDS 9000 Family MIB Quick Reference for more information.
To configure SNMP notifications (traps or informs) using Fabric Manager, follow these steps:
Step 1 Choose Switches > Events > SNMP Trap in the Physical Attributes pane. You see the SNMP
notification configuration in the Information pane.
Step 2 Click the Destinations tab to add or modify a receiver for SNMP notifications.
Step 3 Click Create Row to create a new notification destination. You see the Create Destination Dialog box.
Step 4 Check the switches that you want to configure a new destination on.
Step 5 Set the destination IP address and UDP port.
Step 6 Choose either the trap or inform radio button.
Step 7 Optionally, set the inform timeout and retry values.
Step 8 Click Create to add this destination to the selected switches or click Close to discard any unsaved
changes.
Step 9 Optionally, click the other tabs to enable specific notification types per switch.
Step 10 Click the Apply changes icon to create the entry or click Undo Changes to discard any unsaved
changes.