Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com.
15-16
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-6965-03, Cisco MDS SAN-OS Release 2.x
Chapter 15 Zone Configuration
Zone Set Creation
Configuring the Default Zone Policy
The default zone members are explicitly listed when the default policy is configured as permit or when
a zone set is active. When the default policy is configured as deny, the members of this zone are not
explicitly enumerated when you deactivate the zone set.
You can change the default zone policy for any VSAN by choosing VSANxxx > Default Zone from the
Fabric Manager menu tree and clicking the Policies tab. It is recommended that you establish
connectivity among devices by assigning them to a non-default zone.
The active zone set is shown in italic type. After you have made changes to the active zone set and before
you activate the changes, the zone set is shown in boldface italic type.