Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com.
28-6
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-6965-03, Cisco MDS SAN-OS Release 2.x
Chapter 28 IP Access Control Lists
Associating IP-ACL Profiles to Interfaces
Associating IP-ACL Profiles to Interfaces
To associate the IP-ACL profile to an interface, follow these steps.
Step 1 From Fabric Manager, choose Switches > Security > IP ACL from the Physical Attributes pane. You
see the IP-ACL configuration in the Information pane.
From Device Manager, choose Security > IP ACL. You see the IP-ACL profiles dialog box.
Step 2 Click the Interfaces tab.
You see a list of interfaces and associated IP-ACL profiles.
Step 3 Click the Create Row icon in Fabric Manager or the Create button in Device Manager. You see the
Create Interface dialog box.
Step 4 Optionally, select the switches you want to include in the IP-ACL profile by checking the check boxes
next to the switch address in Fabric Manager.
Step 5 Set the interface you want associated with an IPA-CL profile in the Interface field.
Step 6 Choose the appropriate ProfileDirection radio button (either inbound or outbound).
Step 7 Enter the profile name in the Profile Name field.
Note This profile name must already have been created using the Create Profiles dialog box. If not,
no filters will be enabled until you to go to the Create Profiles dialog box and create the profile.
Step 8 Click Create to associate the profile, or click Close to close the Create Interfaces dialog box without
associating a profile.
You see the newly associated profile in the list of profiles.
Step 9 Repeat Step 8 to create additional associations, or click the Close button to close the Create Interfaces
dialog box.
Removing Associations Between IP-ACL Profiles and Interfaces
To delete an IP-ACL profile, you must first delete all associations between that profile and the interfaces.
To remove associations between IP profiles and interfaces using Fabric Manager, follow these steps:
Step 1 Choose Switches > Security > IP ACL from the Physical Attributes pane.
You see the IP-ACL configuration in the Information pane.
Step 2 Click the Interfaces tab.
You see a list of switches, ACLs, and profile names.