889
FX3G/FX3U/FX3UC Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
A Programming Tool Applicability and Version Upgrade History
A-1 Programming Tool Applicability
31
FNC275-FNC279
Data
Transfer 3
32
FNC280-FNC289
High Speed
Processing 2
33
FNC290-FNC299
Extension File
Register
34
FNC300-FNC305
FX
3U
-CF-ADP
35
SFC•STL
Programming
36
Interrupt
Function
37
Special Device
38
Error Code
A
Version Up
Information
B
Execution Times
Appendix A-1-3 Precautions on Use of (Built-in USB) Programming Port
Make sure to set the contents described in this section when executing circuit monitor, device registration monitor,
program reading/writing, etc. in the FX
3G PLC using the (built-in USB) programming port and GX Developer Ver.
8.72A or later. For GX Developer prior to Ver. 8.72A, communication using the (built-in USB) programming port is not
available.
1. Installation of USB driver (GX Developer Ver. 8.72A or later)
It is necessary to install the USB driver to execute USB communication using the (built-in USB) programming port.
For the USB driver installation method and procedure, refer to the following manual.
→ GX Developer Operating Manual (Startup)
2. Setting in GX Developer (Ver. 8.72A or later)
1) Select [Online] → [Transfer setup...] to open "Transfer setup" dialog box.
2) Double-click [Serial] in [PC side I/F] to open "PC side I/F Serial setting" dialog box.
3) Select "USB (Built-in port)".
4) Click [OK] button to finish the setting.
Select "USB (Built-in port)"
A
display screen is the example of Ver.8.72A.
Double-click it.