Mitsubishi Electronics FX3G Video Gaming Accessories User Manual


 
59
FX3G/FX3U/FX3UC Series Programmable Controllers
Programming Manual - Basic & Applied Instruction Edition
2 Overview (Sequence Program)
2.7 Types and Setting of Parameters
1
Introduction
2
Overview
3
Instruction
List
4
Devices
in Detail
5
Specified the
Device &
Constant
6
Before
Programming
7
Basic
Instruction
8
FNC00-FNC09
Program Flow
9
FNC10-FNC19
Move & Compare
10
FNC20-FNC29
Arith. & Logic
Operation
7 Setting the PLC system (2)
1. Click "PLC system (2)" tab.
2. Only when a latch (battery backed) area for a serial port exists through an extended PLC, select
a channel to be set and put a check mark to "Operate communication setting."
When not performing the communication setting for a serial port, do not put a check mark to
"Operate communication setting."
Set item Contents of setting Setting range
Channel selection Select a channel in which a serial port is set. CH1,CH2
Operate communication setting
Put a check mark when using the selected serial port in "computer link", "no-
protocol communication" or "inverter communication".
Do not put a check mark when transferring and monitoring sequence programs
in GX Developer or when using the selected serial port in simple N : N link or
parallel link.
Protocol
Set each item in accordance with application.
For details on each item, refer to the Data Communication Edition manual.
Data length
Parity
Stop bit
Transmission speed
Header
Terminator
Control line
H/W type
Control mode
Sum check
Transmission control procedure
Station number setting
Time out judge time
Channel selection
This example shows a window in
an FX
3U/FX3UC PLC.