Filter
Top Products
78
S:\agilent\e8285\REFGUIDE\MANUAL\connectr.chp
Chapter 2, Description of Connectors
Connectors
SERIAL PORT 10
This connector is a secondary serial port (SERIAL PORT 9 is the primary), and is
used for serial data exchange with an external device. Applications might include
controlling a mobile station through a proprietary serial bus, entering IBASIC
programs, or sending test results from the IBASIC controller to a connected
controller, disk drive, or terminal.
Operating Considerations
• You must select Port 10 in the Serial Port field on the I/O CONFIGURE screen to
define serial communication settings for SERIAL PORT 10.
• Do not use SERIAL PORT 10 for connecting the test set to a serial printer. Use
SERIAL PORT 9.
• The IBASIC controller sends and receives data to SERIAL PORT 10 using address 10.
• 9-pin sub-miniature D
Pin assignments for this connector are as follows::
Pin 1 - DCD, RS-232
Pin 2 - RX, RS-232
Pin 3 - TX, RS-232
Pin 4 - DTR, RS-232
Pin 5 - Ground
Pin 6 - DSR, RS-232
Pin 7 - RTS, RS-232
Pin 8 - CTS, RS-232
Pin 9 - RI, RS-232