Filter
Top Products
210
S:\agilent\e8285\REFGUIDE\MANUAL\fields.chp
Chapter 4, Description of Fields
Fields
Connected (annunciator)
This annunciator indicates that the Test Set and a mobile station have completed
the signaling steps required to establish a CDMA call, and the Test Set has not had
any indication that the call has ended or should end.
• For a Service Option 1 or Service Option 9 call to the mobile station (initiated by the
Test Set), the mobile station must be answered before this annunciator will light. When
using Service Option 2 or Service Option 32768, the mobile station will automatically
answer a call and the Connected annunciator will light.
• For a call to the Test Set (initiated by the mobile station), the Test Set will automatically
answer the call (if the Answer Mode field on the CDMA CELL SITE
CONFIGURATION screen is set to Auto), and the Connected annunciator will light.
If the Answer Mode field is set to Manual, a message will appear prompting you to
press the ANS key. After you press the ANS key, the Connected annunciator will
light.
When a call is terminated, this annunciator will go out.
NOTE: When a Service Option 1 or Service Option 9 call is initiated from the Test Set, and the mobile
station has acquired the traffic channel, the mobile station will start ringing. During this time,
bit 4 (Alerting) in the CDMA condition register will be set. When a Service Option 1 or
Service Option 9 call is initiated from the mobile station, and Manual is selected in the Answer
Mode field on the CDMA CELL SITE CONFIGURATION screen, a message on the display
will prompt you to press the ANS key. Until the mobile station is answered, bit 4 (Alerting) in
the CDMA condition register will be set.
GPIB Example
“DISP CRXT;STATus:CDMA:CONDition?“
queries the CDMA condition register. Bit 4 will be set when the mobile station is
ringing, and Bit 3 will be set when the Connected annunciator is lit (call was an-
swered).
Screens Where Field is Present
CDMA CALL CONTROL
CDMA SHORT MESSAGE SERVICE
CDMA AUTHENTICATION
Continue
This field is used to restart a paused test.
Screens Where Field is Present
TESTS (Main Menu, Exection Conditions, Printer Setup, IBASIC Controller)