Filter
Top Products
372
S:\agilent\e8285\REFGUIDE\MANUAL\fields.chp
Chapter 4, Description of Fields
Fields
Rgstr SID
This field allows entry of the cell site’s alternate system identification (SID), used
only for registration.
GPIB Example
“DISP CCON;CDMA:CELL:CONFigure:RSID 0“
sets the register network identification of the simulated CDMA cell site
to 0.
Operating Considerations
The Test Set will send the Rgstr NID and Rgstr SID during the registration
process (when the Register field is selected) in an attempt to cause a zone-based
registration to occur. Immediately following the zone-based registration, another
registration is performed using the NID and SID in the Network ID and System
ID fields. The latter values will determine if the mobile station is roaming.
Screens Where Field is Present
CDMA CELL SITE CONFIGURATION
RSSI Thresh
This field is displayed only for NAMPS system type.
This field is used to set the received signal strength threshold of the mobile
station. Exceeding the
RSSI threshold and BER threshold causes the mobile
station to send an
MRI message to the base station reporting it’s current RSSI and
BER.
The :RSETting command is used to control this field.
The query form (that is, :RSETting?) can be used to query the current field value.
Syntax
:RSETting <‘><choice><’>
:RSETting?
Example
OUTPUT 714;"CALLP:AMPS:RSET ‘Imm Resp’"
OUTPUT 714;"CALLP:AMPS:RSET?"
ENTER 714;Stol_set$