Filter
Top Products
295
Chapter 4, Description of Fields
Fields
Meas Cntl
This field allows the selection of either single or continuous measurements.
• Single causes a measurement to be made each time the Arm field is selected.
• Cont causes measurements to re-arm automatically until Single is selected or the
call is terminated.
GPIB Example
“DISP CRXT;TRIGger:MODE:RETRigger SINGle“
sets the measurement mode to single.
Operating Considerations
During remote operation, the default measurement-control setting is continuous.
The displayed mode (Single or Cont) only applies to local (front-panel) operation.
This field does not update when the Test Set is operated remotely.
During manual operation, the default measurement-control setting is single.
See Also
“Measurement Triggering Process” in the Operating Overview chapter of the
E8285A User’s Guide
Screens Where Field is Present
CDMA CELLULAR MOBILE RECEIVER TEST
CDMA CELLULAR MOBILE TRANSMITTER TEST
CDMA GATED POWER (unlabeled)
Message Data Mode
This field is selects either ASCII or Hex data for the SMS message.
See Also
"Enter ASCII Data" field on page 245
"Enter Hex Data" field on page 245
Screens Where Field is Present
CDMA SHORT MESSAGE SERVICE