Filter
Top Products
368
S:\agilent\e8285\REFGUIDE\MANUAL\fields.chp
Chapter 4, Description of Fields
Fields
RF Gen Freq
This field is displayed on the screens listed below when the RF Display field on
the CONFIGURE screen is set to
Freq.
This field sets the RF Generator’s (or CDMA generator’s) frequency.
GPIB Example
“RFG:FREQ 815MHZ“
sets the RF generator to 815 MHz.
See Also
RF Display
field description, on page 367
Screens Where Field is Present
DUPLEX TEST
SPECTRUM ANALYZER (When the
Controls field is set to RF Gen)
RX TEST
RF GENERATOR
CDMA CALL CONTROL
CDMA REVERSE CHANNEL SPECTRUM (When the
Controls field is set to
CDMA Gen)
RF Gen Volts
This field specifies whether you want RF voltages expressed as the voltage across
a 50 ohm load, or the open circuit voltage (emf).
Operating Considerations
This setting affects the RF Generator’s and the Tracking Generator’s amplitudes.
Screens Where Field is Present
CONFIGURE