Filter
Top Products
224
S:\agilent\e8285\REFGUIDE\MANUAL\fields.chp
Chapter 4, Description of Fields
Fields
Syntax
:MODE <’><DATA/MEAS><’>
:MODE?
:NDMMode <’><NDATA/NMEAS><’>
:NDMMode?
Example
OUTPUT 714;"CALLP:MODE ’DATA’"
OUTPUT 714;"CALLP:MODE?"
ENTER 714;Screen$
OUTPUT 714;"CALLP:NAMP:NDMMode ’NDATA’"
OUTPUT 714;"CALLP:NAMP:NDMMode?"
ENTER 714;Screen$
Setting the Display field to Data
When the Display field is set to Data the top right-hand portion of the CALL
CONTROL
screen is used to display decoded data message(s) received from the
mobile station on the reverse control channel or the reverse voice channel.
If the data message(s) received from the mobile station can be correctly decoded,
the decoded message contents are displayed.
Figure 55 shows an example of a
correctly decoded reverse control channel data message being displayed in the top
right-hand portion of the screen.
If the data message(s) cannot be correctly decoded, the raw data message bits are
displayed in hexadecimal format.
See “Using the Analog Call Processing Subsystem” chapter in the E8285A
Application Guide for more information.