Filter
Top Products
202
S:\agilent\e8285\REFGUIDE\MANUAL\fields.chp
Chapter 4, Description of Fields
Fields
Example
OUTPUT 714;"CALLP:NTACS:CEXT:ACT?"
OUTPUT 714;"CALLP:NTACS:CEXT:SETT ‘NARROW’"
OUTPUT 714;"CALLP:NTACS:CEXT:SETT?"
ENTER 714;Last_ord_sent$
Screens Where Field is Present
CALL CONTROL
Ch Offset
Use the channel offset field to enter the frequency difference between the Tune
Freq
setting and the center of the adjacent channels you want to measure. This is
an absolute value; only positive values can be entered. See
figure 54 .
Screens Where Field is Present
ADJACENT CHANNEL POWER
Chan Space (User Defined)
This field specifies the RF channel spacing when the RF Display field is set to
Chan, and the RF Chan Std field is set to USER-DEF.
For example, entering
25 kHz causes a 25 kHz spacing between each channel. If
the receive frequency for channel 1 is 150.500 MHz, channel 2’s receive
frequency would be 150.525 MHz.
Operating Considerations
The value of this field is only used if the RF Display field is set to Chan, and the
RF Chan Std field is set to USER-DEF.
See Also
(Gen)-(Anl)
field description, on page 269
RF Chan Std field description, on page 365
Base Freq (User Defined) field description, on page 183
Screens Where Field is Present
CONFIGURE