Filter
Top Products
255
Chapter 4, Description of Fields
Fields
Screens Where Field is Present
CDMA MOBILE REPORTED PILOT STRENGTH
Expected T_Drop
This field is displayed only when TIS/EIA-95B is selected in the "Protocol" field
on page 346
. Refer to ANSI/TIA/EIA-95-B, 6.6.6.2.6, Set Maintenance, for
additional information.
This field displays an integer value representing an expected power level
threshold. The purpose of this calculation is to determine the approximate power
level threshold that will cause the mobile station to start its drop timer.
GPIB Example
“CDMA:MOBile:PARM:ETDRop?“
queries the Expected T_Drop value calculated by the Test Set.
Operating Considerations
If there is a call connected with the Soft Handoff field On and the status of both
pilot signals is Active, the mobile station should report To Drop (in the Status
field) if one of the active pilot’s signal strength has decreased to less than
Expected T_Drop and a pilot strength message was sent.
The value displayed in this field is calculated from the current T_Drop field and,
if
"Soft Slope" field on page 400 is not 0, the "Drop Intcpt" field on page 237.
The table at the top of the CDMA MOBILE REPORTED PILOT STRENGTH
screen can be cleared by selecting the
"Pilot Meas (Clear)" field on page 335
See Also
T_Add
field description, on page 420
Drop Intcpt
field description, on page 237
Soft Slope
field description, on page 400
Softer Handoff
field description, on page 399
Screens Where Field is Present
CDMA MOBILE REPORTED PILOT STRENGTH