Filter
Top Products
369
Chapter 4, Description of Fields
Fields
RF In
This field is used to indicate reverse channel path losses or gains between the
mobile station and the RF IN/OUT port.
•Enter a positive value to indicate a gain (such as amplifier gain).
•Enter a negative value to indicate a loss (such as cable loss).
The RF In
field is displayed only when RF In is selected in the Input Port
field.
GPIB Example
“CONF:OFL:RF:IN -1”
enters a path loss of 1 dB between the RF IN/OUT port (input path only) and the
mobile station.
The value entered into this field is applied only when the
RF Level Offset
field is set to
On.
See Also
RF Level Offset
field description, on page 369
Screens Where Field is Present
CONFIGURE
RF Level Offset
This field enables/disables the RF level offsets entered in the RF In/Out,
Duplex Out, and Antenna In fields below it.
• When set to On, the RF Generator’s amplitude and RF Analyzer’s power measurement
are offset by the values entered in these fields.
• When set to Off, the values in these fields are ignored.
See Also
Antenna In
field description, on page 167
Duplex Out field description, on page 242
RF In field description, on page 369
Screens Where Field is Present
CONFIGURE