Filter
Top Products
6 - 18
MELSEC-Q
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
(5) Position-speed switching operation positioning data No. 3
(4) Speed-position switching operation (positioning data No. 2)
(In the ABS mode, new movement amount write is not needed.)
(6) High-level positioning control
(7) Fast OPR command and fast OPR command storage OFF
(Not required when fast OPR is not used)
(1) When dedicated instruction (PSTRT1) is used
No. 8 Positioning start program
(When fast OPR is not made, contacts of M3 and M4 are not needed.)
(When M code is not used, contact of X04 is not needed.)
(When JOG operation/inching operation is not performed, contact of M7 is not needed.)
(When manual pulse generator operation is not performed, contact of M9 is not needed.)
287
295
301
307
313
320
326
338
345
359
372
384
332
<Positioning data No. 2 setting>
<Speed-position switching signal enable setting>
<Speed-position switching signal prohibit setting>
<New movement amount write>
<Positioning data No. 3 setting>
<Position-speed switching signal enable setting>
<Position-speed switching signal prohibit setting>
<New speed write>
<Block positioning (7000) write>
<Fast OPR command OFF>
<Fast OPR command storage OFF>
<Positioning start command pulse>
<Positioning start command hold>
<Positioning start execution>
<Positioning start command storage OFF>