Filter
Top Products
Local Cluster Configuration
Polycom, Inc. 74
See also:
Local Cluster Configuration
Local Cluster Configuration Procedures
Add Guest Port Dialog
The Add Guest Port dialog appears when you click the Add button next to the Unauthorized ports list in
the SIP Settings section of the Signaling Settings page. It lets you add a port to the list of ports used for
“unauthorized” or “guest” calls.
The following table describes the fields in the Add Guest Port dialog.
Require mutual
authentication (validation
of client certificates)
Check the box to enable mutual TLS, requiring each caller to present a valid
certificate.
Note: This setting is enabled and locked if Unlock SIP Settings mutual
authentication option on the Signaling Settings page option is unchecked
on the Security Settings page. See Security Settings.
Unauthorized ports Lists the ports used by your SBC(s) for untrusted calls, showing the transport
type for each and, for TLS, whether a certificate is required. The
Authentication column indicates whether calls to that port are passed without
challenge, challenged for authentication credentials, or blocked.
Click Add to add a port to the list (see Add Guest Port Dialog). Click Edit to
edit the selected entry (see Edit Guest Port Dialog) or Delete to delete it.
Unauthorized prefixes Lists the prefixes used by your SBC(s) for untrusted calls. The Strip Prefix
column indicates whether the RealPresence DMA system should immediately
strip the prefix. The Authentication column indicates whether calls to that
port are passed without challenge, challenged for authentication credentials,
or blocked.
Click Add to add a prefix to the list (see Add Guest Prefix Dialog). Click Edit
to edit the selected entry (see Edit Guest Prefix Dialog) or Delete to delete it.
Field Description
Port The SIP signaling port number for this entry.
This is the port number that an SBC is configured to use for untrusted calls to
the RealPresence DMA system via the transport specified below.
Transport To use this guest port for unencrypted SIP connections, select either TCP or
UDP/TCP from the list. To use this port for encrypted SIP connections, select
TLS.
Field Description