Filter
Top Products
set port 89
See Also
clear ap on page 70
clear port type on page 74
set port type ap on page 97
set system countrycode on page 61
set port Administratively disables or reenables a port.
Syntax — set port {enable | disable} port-list
enable — Enables the specified ports.
disable — Disables the specified ports.
port-list — List of physical ports. MSS disables or reenables all the
specified ports.
Defaults — All ports are enabled.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — A port that is administratively disabled cannot send or receive
packets. This command does not affect the link state of the port.
Examples — The following command disables port 6:
WX1200# set port disable 6
success: set "disable" on port 6
The following command reenables the port:
WX1200# set port enable 6
success: set "enable" on port 6
See Also
reset port on page 87