Filter
Top Products
19
RF DETECTION COMMANDS
MSS automatically performs RF detection scans on enabled and disabled
radios to detect rogue access points. A rogue access point is a BSSID
(MAC address associated with an SSID) that does not belong to a 3Com
switch and is not a member of the ignore list configured on the seed
switch of the Mobility Domain. The ignore list is a list of third-party
(friendly) BSSIDs that are not rogues.
MSS can issue countermeasures against rogue devices to prevent clients
from being able to use them.
You can configure RF detection parameters only on the seed switch of a
Mobility Domain.
Commands by
Usage
This chapter presents RF detection commands alphabetically. Use
Table 101 to locate the commands in this chapter based on their use.
Table 101 RF Detection Commands by Usage
Type Command
Rogue Information display rfdetect clients on page 637
display rfdetect mobility-domain on page 644
display rfdetect data on page 642
display rfdetect visible on page 650
display rfdetect counters on page 640
Countermeasures display rfdetect countermeasures on page 639
Permitted Vendor List set rfdetect vendor-list on page 660
display rfdetect vendor-list on page 649