Filter
Top Products
12
STP COMMANDS
Use Spanning Tree Protocol (STP) commands to configure and manage
spanning trees on the virtual LANs (VLANs) configured on a wireless LAN
switch or controller, to maintain a loop-free network.
STP Commands by
Usage
This chapter presents STP commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 74 STP Commands by Usage
Type Command
STP State set spantree on page 501
display spantree on page 488
display spantree blockedports on page 492
Bridge Priority set spantree priority on page 510
Port Cost set spantree portcost on page 505
set spantree portvlancost on page 508
display spantree portvlancost on page 494
clear spantree portcost on page 484
clear spantree portvlancost on page 485
Port Priority set spantree portpri on page 507
set spantree portvlanpri on page 509
clear spantree portpri on page 485
clear spantree portvlanpri on page 486
Timers set spantree fwddelay on page 503
set spantree hello on page 503
set spantree maxage on page 504
Fast Convergence set spantree portfast on page 506
display spantree portfast on page 493