Filter
Top Products
408 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
See Also
display service-profile on page 353
set ap radio auto-tune max- retransmissions on page 385
set radio-profile auto-tune power-config on page 406
set radio-profile
auto-tune
power-lockdown
Locks down the current power settings on all radios in a radio profile. The
power settings that are in effect when the command is entered are
changed into statically configured power settings on the radios.
RF Auto-Tuning of power is then disabled in the radio profile.
Syntax —
set radio-profile name auto-tune power-lockdown
name—Radio profile name.
Defaults — By default, when RF Auto-Tuning of power is enabled,
power settings continue change dynamically based on network
conditions.
Access — Enabled.
History —Introduced in MSS Version 5.0.
Usage — To save this command and the static power configuration
commands created when you enter this command, save the
configuration.
Examples — The following command locks down the power settings for
radios in radio profile rp2:
WX1200# set radio-profile rp2 auto-tune power-lockdown
success: change accepted.
See Also
set ap radio auto-tune max-power on page 384
set radio-profile auto-tune channel-lockdown on page 405
set radio-profile auto-tune power-config on page 406
set radio-profile auto-tune power-interval on page 407
set radio-profile auto-tune power-ramp-interval on page 409
display radio-profile on page 350