Filter
Top Products
732 CHAPTER 24: BOOT PROMPT COMMANDS
See Also
change on page 725
create on page 726
delete on page 727
next on page 735
fver Displays the version of a system image file installed in a specific location
on a WX switch.
Syntax —
fver {c: | d: | e: | f: | boot0: | boot1:}
[filename]
c: — Nonvolatile storage area containing boot partition 0 (primary).
d: — Nonvolatile storage area containing boot partition 1 (secondary).
e: — Primary partition of the flash card in the flash card slot.
f: — Secondary partition of the flash card in the flash card slot.
boot0: — Boot partition 0.
boot1: — Boot partition 1.
filename — System image filename.
Defaults — None.
DEVICE Location of the system image file:
c: — Nonvolatile storage area containing boot partition 0
d: — Nonvolatile storage area containing boot partition 1
e: — Primary partition of the flash card in the flash card slot
f: — Secondary partition of the flash card in the flash
card slot
boot0 — boot partition 0
boot1 — boot partition 1
FILENAME System image file name.
FLAGS Number representing the bit settings of boot flags to pass to
the booted system image.
OPTIONS String up to 128 bytes of boot options to pass to the booted
system image.
Table 121 Output of display command (continued)
Field Description